ALWAYS REMOVE THE SAFETY KEY AND BATTERY BEFORE PERFORMING ANY ADJUSTMENTS, MAINTENANCE, OR REPAIRS TO YOUR MOWER.
PROBLEM
The Mower runs, but the cutting performance is unsatisfactory, or there is a loss of power.
The Mower is hard to push.
The Battery loses its charge quickly.
The Mower rear Bagger is collecting grass poorly.
CORRECTIVE ACTION
⇒The Battery was probably not at full charge prior to Mowing. Charge the Battery, if necessary.
⇒The Blade may be dull, bent, loose or damaged. Remove the Safety Key and the Battery, turn the Mower over, and check the condition of the Blade. Sharpen, tighten, or replace the Blade, if necessary.
⇒The grass may be too high or too thick for the cutting height. Raise the cutting height or narrow your cutting swath and try again.
⇒The grass may be too high or too thick for the cutting height. Raise the cutting height or narrow your cutting swath and try again.
⇒The Wheels may not be rotating freely. Remove the Safety Key and the Battery, turn the Mower over, and check the Wheels for damage.
⇒The Battery was probably not at full charge prior to Mowing. Charge the Battery, if necessary.
NOTE: You will need to charge a new Battery at least five (5) times to achieve maximum cutting time.
⇒The grass may be too high or too thick for the cutting height. Raise the cutting height or narrow your cutting swath and try again.
⇒The Battery may be getting old. After some time, usually about five (5) years, you will need to replace the Battery.
⇒The rear Bagger is full. Empty the Bagger, and clean it if necessary.
⇒The grass is too long or the Mower is cutting too low. Raise the cutting height.
⇒The Mower is moving too fast, slow down.
⇒The mesh holes in the rear Bagger are clogged, clean them out.
⇒The rear Bagger is wet. Allow it to dry thoroughly before using it again.
42 |
