Advancing the Cord
Each time the Trimmer starts or comes to a complete stop, the Trimmer’s Cutting Cord automatically advances and cuts itself to
You can also manually advance the Cord.
1.Release the orange Control Bar to stop the Trimmer motor and remove the Safety Key.
2.Push in the white Button on the side of the Spool Housing (Figure 37) and pull the Cord to advance it. The Cord advances in small increments so you might have to push the Button a few times.
NOTE: Try not to advance the Cutting Cord past the Trimmer Shield. If you do pull out too much Cord, the Cutter on the Trimmer Shield automatically trims the length of the Cord (Figure 38).
BE CAREFUL, THE EXCESS CORD WILL FLY OFF WHEN YOU START THE TRIMMER AND COULD BE DANGEROUS.
Cord Cutter
White Button
Housing
Figure 37 | Figure 38 |
Safety Tips for using the Trimmer
Following these tips will provide safe operation and enhance the performance of your Trimmer:
•Always stop the motor before toggling the Power/Mode Switch.
•You can adjust the cutting height of the Trimmer by raising or lowering the Mower’s cutting height level. Make sure you first stop the motor and remove the Safety Key before changing the height.
•Stop the motor and remove the Safety Key before changing the position of the Trimmer Head.
•The Battery will drain more quickly in the Edger mode. You can realistically expect up to 45 minutes of use in the Edger mode, and approximately one (1) hour in Trim mode. This is when having an extra charged Battery comes in handy. Be sure to remove the Safety Key when you change the Battery.
•Be sure to clean the Trimmer Head frequently keeping the cooling vents and air intake holes free of debris.
48 |
