Neuton CE 6.2 manual Charging the Battery in the Mower

Charging the Battery

You must charge the Battery before using your Mower for the first time and after every use. You can charge the Battery in or out of the Mower. The performance of your Mower is the same, regardless of which charging method you choose.

WHILE THE BATTERY IN YOUR MOWER WAS CHARGED AT THE FACTORY, YOU MUST RECHARGE IT FULLY (EIGHT (8) TO TWENTY-FOUR (24) HOURS) BEFORE USING YOUR MOWER. OTHERWISE, YOU MAY DECREASE THE CHARGING CAPACITY OF THE BATTERY. AGAIN, USE ONLY THE CHARGER SUPPLIED WITH THE MOWER.

As the Battery ages, you may need to charge the Battery longer, even up to twenty-four (24) hours. A good time to consider purchasing a replacement Battery is when the Battery takes longer than twenty-four (24) hours to charge.

USE NORMAL HOUSEHOLD VOLTAGE (110 VOLTS) WHEN CHARGING THE BATTERY. PLUG THE CHARGER DIRECTLY INTO THE ELECTRICAL OUTLET. DO NOT ABUSE THE CORDS. NEVER CARRY THE CHARGER BY THE CORD. ALWAYS PULL THE PLUG – AND NOT THE CORD – WHEN DISCONNECTING THE CORDS FROM THE ELECTRICAL OUTLET (WALL OUTLET) AND FROM THE CHARGER.

NOTE: When using an extension cord with your Charger, use a heavy-duty extension cord of a type “suitable for outdoor use” (although you should never charge the Battery in the open outdoors).

ALWAYS CONNECT THE CHARGER TO THE BATTERY FIRST, AND THEN PLUG THE CHARGER INTO THE WALL OUTLET. WHEN UNPLUGGING, REVERSE THE PROCESS; UNPLUG THE CHARGER FROM THE WALL OUTLET FIRST, AND DISCONNECT IT FROM THE BATTERY.

Charging the Battery in the Mower

Figure 24

28

Charger in Mating Plug	1.	Make sure all four (4) Wheels of the Mower touch the
		floor.
	2.	Open the Access Cover and remove the Safety Key.
	3.	Remove the Protective Plug from the Charger
		Receptacle on top of the Battery and plug in the round
		Charger Connector Plug (Figure 24).
	4.	Plug the Charger into a wall outlet. The RED light on the
		Battery will light up indicating a connection between
		the Battery and Charger.

NOTE: A full charge takes at least eight (8) hours, and may take up to twenty-four (24) hours. For the first five (5) hours, the Charger will be warm to the touch. This is normal and does not indicate a problem.

1-866-NEUTON1 (638-8661) www.neutonpower.com