NOTE: Mount the top trim panel so that it sits in front of the top of the side trim panels..
9.Obtain the brass trim kit provided with insert kit and slip over the top and sides of trim panels. (Top ends of brass may need to be trimmed to fit.)
10.Using insulation provided, peel and stick to back of panels overlapping fireplace dimensions by 1" on each side and top. (See Figure 4.)
11.Next using high heat silicone or furnace cement run heavy bead of caulking around where panels meet the stove. (See Figure 4.)
12.Slide the unit back into the fireplace. Check to be sure that the trim panels (and brass) are properly positioned and lie flat against the front of the fireplace. If panels are out of position, slide the unit out and reset by loos ening the mounting screws and repositioning in the slot. With bar lift stove up in front. Place insulation across front and the surface of hearth or bottom of fireplace to make complete seal.
13.To check seal of panels, use candle flame and go around the entire area sealed by silicone and insulation. If flame leans toward inside of fireplace, add additional insulation. This ensures an airtight seal.
FIGURE 4
FINAL CHECK
1.Recheck the specified clearances.
2.Remove all foreign material from the firebox area.
3.Open the primary air draft.
4.Plug the power cord into a 115V AC outlet if optional motor is being used. “Do not run power cord under unit or in high traffic areas.
5. Place | rumpled pieces of newspaper in the stove. Light it and close the door. Ensure that the |
stove | draws properly through the primary draft. |
6.Check for smoke leaks around the door.
7. Open the door and check for smoke escaping from the front of the stove. Smoking usually indicates
adefective or poorly positioned chimney. Some chimneys with a marginal draft can be pre- heated by lighting newspaper and holding it near the open damper with a poker or fire tong. Once the chimney heats up, a proper draft can usually be obtained.
If a thorough review of the Troubleshooting Guide in the rear of the manual does not reveal the problem, contact your dealer for assistance.
8
