PREPARING THE LOCATION FOR ROOM HEATER
1.Select an installation location that will give the best airflow from the front of the heater to the remainder of the home.
2.Placetheprotectivefloorpadin position. For minim floor protection (See Pages 12,20,21,23.)
3.Place the unit on the pad making sure the minimumum clearance specifications are met.
4.Lightly mark with a pencil the location of the pedestal on the protective pad.
5.Next, remove the four (4) screws holding the heater to the stand. Position heater out of the way of the installation area.
6.Check that the pedestal stand is still aligned with the marks on the protective pad, now mark the outside air opening in bottom of pedestal stand on to the pad.
7.Next, mark the center line of the outside air opening. Set stand aside for now.
8.Next, cut a 4 1/4" diameter hole in the pad and continue through the floor.
9.Now, reposition the pedestal stand and set on the pad being sure to line the stand up with the reference marks.
10.Using an electric drill and 3/8" masonry bit, drill four (4) holes in the protective pad using the holes in the bottom side lips of the pedestal stand as a guide. Be careful to drill only through the pad and not into the floor. Change the bit to a 1/4" metal bit and drill through the floor.
11.Using the four (4) 3/8" x
12.Set the heater back onto the stand and resecure using the screws.
13.Obtain the outside air duct from the box in the pedestal kit marked FA P21B.
26
