New Media Technology 9212 manual Set the output’s state to ON/OFF

Click the test-itselfbutton and you will see the figure above. The states of OUT1, OUT2, OUT3 and OUT4 will separately keep in ON for 1 second, 3 seconds, 6 seconds and 8 seconds, then all back to OFF. After one period, four outputs will keep in OFF state for the same time. This process will repeat until you click the reset or cancel button.

2. Set the output’s state to ON/OFF

Click the output you want to change, set it to ON or OFF state and click apply button to finish the setting.

3.Set one output be in ON/OFF state at the appointed time

You can set the state when one output starts, either ON or OFF. You can also set the delay time and the action when the delay time is up. Then click apply button to confirm it. The example shows in the figure above means the OUT3 will be in ON state when it starts and will changes the state to OFF after 30 seconds.

4. Reset the ON/OFF settings

Click the reset button you can cancel the previously output settings.

- 16 -