Step 1 Turn the Camera On

Turning the Camera On and Off

•When the camera is turned on, the power-on lamp (green) lights and the monitor is turned on (the power-on lamp turns off when the monitor is turned on).

•To turn off the camera, press the power switch. Both the monitor and the power-on lamp are turned off.

•To turn on the camera in playback mode, press and hold the c(playback) button.

•When Record GPS data in GPS options of the GPS options menu is set to On or while recording logs, GPS functions and log recording will continue to operate even after the camera is turned off (A83).

CPower Saving Function (Auto Off)

If no operations are performed for a while, the monitor will turn off, the camera will enter standby mode, and the power-on lamp will flash. If no operations are performed for another 3 minutes, the camera will turn off automatically.

•While the camera is in standby mode, the monitor is turned on again when any of the following buttons is pressed.

➝Power switch, shutter-release button, A(shooting mode) button, c(playback) button, or b(emovie-record) button

•The time that elapses before the camera enters standby mode can be changed using the Auto off setting in the setup menu (A94).

•By default, the camera enters standby mode in about 1 minute when you are using shooting mode or playback mode.

•If you are using the AC Adapter EH-62F (available separately), the camera enters standby mode after 30 minutes. This setting cannot be changed.

CNote on Battery Drain

Battery power drains faster than usual while the camera is recording log data (A89) or using a Wi-Fi connection (A91).

Playback and Shooting of Basics The

21