Memory card access lamp

Live View

Framing Photographs in the Monitor

Follow the steps below to take photographs in live view.

1 Rotate the live view switch.

The view through the lens will be displayed in the monitor.

Live view switch

2Position the focus point.

Position the focus point over your subject as described on page 121.

Focus point

3 Focus.

Press the shutter-release button halfway. The

focus point will flash green while the camera focuses. If the camera is able to focus, the focus

point will be displayed in green; if the camera is unable to focus, the focus point will flash red (note that pictures can be taken even when the focus point flashes red; check focus in the monitor before shooting). Except in iand j modes, exposure can be locked by pressing the A (L) button.

4 Take the picture. Press the shutter-release button the rest of the way down. The monitor turns off and the memory card access lamp lights during recording. Do not remove the battery or memory

card until recording is complete. When shooting is complete, the photograph will be displayed in

the monitor for a few seconds before the camera returns to live view mode. To exit, rotate the live view switch.