Nikon 25438, D60BODY Insert the battery, Charging and Inserting the Battery, Removing the Battery

Charging and Inserting the Battery

1.4Charging is complete when the CHARGE lamp stops blinking. Remove the battery from the charger and unplug the charger.

CHARGE lamp

1000mAhEL9	4V.7
-EN

2Insert the battery.

2.1After confirming that the power switch is in the off position, open the battery chamber cover.

2.2Insert a fully charged battery as shown at right. Close the battery chamber cover.

	2	First
		Steps
		1
hA	E
L9EN-

Be sure that the battery contacts are facing down.

s

BRemoving the Battery

Turn the camera off and confirm that the memory card access lamp is off before removing the battery.

BThe Battery and Charger

•Read and follow the warnings and cautions on pages ii–iii and 164–166 of this manual, together with any warnings and instructions provided by the battery manufacturer.

•Do not use the battery at ambient temperatures below 0 °C (32 °F) or above 40 °C (104 °F). During charging, the temperature should be in the vicinity of 5–35 °C (41–95 °F). For best results, charge the battery at temperatures above 20 °C (68 °F). Battery capacity may drop if the battery is charged or used at lower temperatures.

•The battery may be hot immediately after use. If so, wait for the battery to cool down before charging.

•Replace the supplied terminal cover after removing the battery from the camera or the quick charger to avoid shorting the battery.

• Unplug the quick charger when it is not in use. 17