Nikon S1200pj Error Messages

Error Messages

The following table lists the error messages and other warnings displayed in the monitor, as well as the solutions for dealing with them.

	Display	Description		Solution	A
	O(blinks)	Clock not set.	Set date and time.		E61
	N	Battery exhausted.	Charge or replace the battery.		16, 18
	Battery exhausted.
			Turn off camera, and allow
			battery to cool down before
			resuming use. After five
			seconds, the monitor will turn
	P	Battery temperature is	off and the power-on lamp
	Battery temperature		will blink rapidly. After the		23
		high.
	high		lamps blink for three minutes,
			the camera will turn off
			automatically. Pressing the
			power switch also turns off
			the camera.
	P		The camera turns off
	The camera will turn	The camera has become	automatically. Leave the		81
	off to prevent	hot.	camera off until it has cooled
	overheating.		and then turn it on again.
	N	There is no signal from	Input a signal from the
	No signal. The				81
		the connected device.	connected device.
	camera will turn off.
Reference
	Close the projector		• Close the projector cover		81
	P		• To resume projection, close
		The projector cover is		the projector cover, turn
Section	cover	opened.		the camera off and back on,
				cover.
				and open the projector
	Q(● blinks red)	Camera cannot focus.	•	Refocus.	28, 31
			•	Use focus lock.	68
	P	Camera cannot perform	Wait until message clears
	Please wait for the
		other operations until	from display automatically		–
	camera to finish
		recording is complete.	when recording is complete.
	recording.
	N	Write-protect switch is	Slide write-protect switch to
	Memory card is				–
		in “lock” position.	“write” position.
	write protected.

E82