Nikon S6200, 26277 manual Troubleshooting, Hide info is selected for Photo info, Select Show info

Troubleshooting

	Problem	Cause/Solution	A
		• Camera is off.	21
		• Standby mode for saving power: press the	2, 21
		power switch, the shutter-release button, A
		button, cbutton, or b (e movie-record)
		button.
	Monitor is blank.	• When flash lamp blinks, wait until flash has	56
		charged.
		• Camera and computer are connected via USB	74, 77
		cable.
		• Camera and TV are connected via audio/video	74, E21
		cable or HDMI cable.
	Monitor is hard to read.	• Adjust monitor brightness.	88, E58
		• Monitor is dirty. Clean monitor.	F6
		• If camera clock has not been set, “Date not set”
		indicator blinks during shooting and movie
		recording. Images and movies saved before
	Date and time of	clock is set are dated “01/01/2011 00:00”. Set the	22, 88,
	recording are not correct.	correct time and date from the Time zone and	E55
		date option in the setup menu.
		• Check camera clock regularly against more
		accurate timepieces and reset as required.
	No indicators displayed in	Hide info is selected for Photo info.	88, E58
Technical	monitor.	Select Show info.
	Print date not available.	Camera clock has not been set.	22, 88,
			E55
Notes
	images even when Print	support Print date.	88, E60
	Date not imprinted on	• The current shooting mode is one that does not
and	date is enabled.	• The date cannot be imprinted on movies.
	Screen for setting time
Index
	zone and date is displayed	Clock battery is exhausted; all settings were	22, 23
	when camera is turned on.	restored to their default values.
	Camera settings reset.
		Battery temperature is high. Turn off camera and
	Monitor turns off, and the	allow battery to cool down before resuming use.
	power-on lamp blinks	After the lamp blinks for three minutes, the	21
	rapidly.	camera will turn off automatically. Pressing the
		power switch also turns off the camera.

F8