UTP Receivers
V212-NVT 7631 Receiver, converts UTP video to composite up to 500 ft from transmitter
V213-NVT 6518 Receiver, converts UTP video to composite up to 1000 ft from transmitter
V652R-NVT 7453 Receiver, converts UTP video to composite up to 3000 ft from transmitter (does
not support Vicoax systems)
V1613-NVT 7648 16-channel Hub receiver, converts UTP video to composite up to 1000 ft from
each transmitter
V1662-NVT 6519 16-channel Hub receiver, converts UTP video to composite up to 3000 ft from
each transmitter (does not support Vicoax systems)
Installation

Unpacking and Inspection

All Vicon equipment is tested and inspected before leaving the factory. It is the carrier’s responsibility to
deliver the equipment in the same condition as it left the factory.

Inspection for Visible Damage

Immediately inspect the cartons upon delivery. Make a note of any visible damage on all copies of the
carrier’s freight bill. Make sure the carrier’s agent (the person making the delivery) signs the note on all
copies of the bill. If the agent does not have claim forms, contact the carrier’s office.

Inspection for Concealed Damage

As soon as possible after delivery, unpack the unit and inspect it for concealed damage. Do not discard the
carton or packing materials. If the unit is damaged, contact the carrier immediately and request forms for filing
a damage claim. Make arrangements for a representative of the carrier to inspect the damaged equipment. If
the equipment must be returned for repair, follow the Shipping Instructions at the end of this manual.
2 • Installation XX152-02-00 Rev 1204 SurveyorVFT Fixed Camera Dome