Disassembly

The SurveyorVFT Fixed Camera Dome can be easily disassembled by removing the camera mechanism from the housing or enclosure. A safety cord is always available to safely hang the camera mechanism while assembling or disassembling.

In-Ceiling Installation

1.Gently pull down on the lower dome’s outside edge, with two hands, until all molded tabs snap out of place.

2.Push in the tabs to release the camera mechanism from the enclosure. It will hang from the safety cord.

3.If it is necessary to completely remove the camera mechanism, disconnect the safety cord clip and all cables.

Pendant Installation

1.On outdoor version only, loosen the four (4) trim ring screws from the outdoor lower dome.

2.Gently pull down on the lower dome’s outside edge, with two hands, until all molded tabs snap out of place.

3.Push in the tabs on the housing until the camera mechanism is released.

4.Allow the SurveyorVFT to gently drop down until it is supported by the safety cord.

5.If it is necessary to completely remove the SurveyorVFT, remove all cable connections and disconnect the clip on the end of the safety cord from the tab on the enclosure.

16 Installation

XX152-02-00 Rev 1204 SurveyorVFT Fixed Camera Dome

Page 26
Image 26
Nikon XX152-02-00 specifications Disassembly, In-Ceiling Installation, Pendant Installation