Camera Power Connections

Note: Vicon systems and components, like most electronic equipment, require a clean, stable power source. Voltage irregularities such as surges, drops, and interruptions can affect the operation of your equipment and, in severe cases, damage certain components. Vicon strongly recommends the use of line conditioners, voltage regulators, and uninterruptible power supply (UPS) systems.

Power is connected through a two-position detachable screw terminal connector on the PC board (P8). Refer to Figure 4. Refer to Table 2 for the input power connections.

1.Find the detachable power cable connector supplied on the PC board.

2.Strip approximately 1 in. (25 mm) of insulation off power cables. Then strip off approximately 0.25 in. (6 mm) of insulation off each individual wire. Attach the camera power cables to the connector according to Table 2.

3.Press the cable connector onto the board connector. The connector is keyed to prevent incorrect installation.

The camera is shipped prepared for 24 VAC.

Figure 4

Camera/Lens PC Board

Table 2

Camera Power Connections

Pin Number

Function

1

24 VAC Input

2

24 VAC Return

XX152-02-00 Rev 1004 SurveyorVFT Fixed Camera Dome

Installation 9

Page 19
Image 19
Nikon XX152-02-00 specifications Camera Power Connections