ENGLISH | USER MANUAL |
|
|
|
|
USE
WARNING!
On some points of the machine there are some adhesive plates indicating:
– DANGER
–WARNING
–CAUTION
–CONSULTATION
While reading this Manual, the operator must pay particular attention to the symbols shown on the plates. Do not cover these plates for any reason and immediately replace them if damaged.
BEFORE MACHINE START-UP
Brush or pad-holder installation
NOTE
Use either the brush (42) or the
1.Insert the positioning pin (24) and disengage the machine transport/parking device (23b).
2.Lift the
3.Place the brush (42) or the
4.Lower the deck (10) by using the handlebar (2).
5.Connect the power supply cable (21) to the electrical mains.
6.Engage the
Brush/pad application guide (suggestions only)
| Types of brushes available | Midlite Grit 180 | Midgrit 240 | Prolite | Union Mix | |
|
|
|
|
|
|
|
|
| Concrete |
|
|
|
|
|
|
|
|
|
|
|
|
| Terrazzo floor |
|
|
|
|
|
|
|
|
|
|
|
General cleaning | Ceramic tiles/quarrystones |
|
|
|
| |
|
|
|
|
| ||
Marble |
|
|
|
| ||
|
|
|
|
|
| |
|
| Vinyl tiles |
|
|
|
|
|
| Rubber tiles |
|
|
|
|
|
| Rubber tiles |
|
|
|
|
Polishing |
| Marble |
|
|
|
|
|
| Vinyl tiles |
|
|
|
|
|
|
|
|
|
|
|
Squeegee installation
7.Install the squeegee (11) and fasten it with the handwheels (12), then connect the vacuum hose (22) to the squeegee.
Solution tank filling
8.Open the recovery water tank cover (41) and engage the support rod (59).
9.Use the filler neck (35) to fill the tank (27) with a solution suitable for the work to be performed. Do not fill the solution tank completely, leave a few centimetres from the edge.
Always follow the dilution instructions on the label of the chemical product used to prepare the solution. The solution temperature must not exceed 40°C.
CAUTION!
Use only
Adjustments
10. Adjust the handlebar (2) with the knobs (3) to reach a comfortable position.
10
SCRUBTEC 343E | 909 6315 |