ENGLISH USER MANUAL
TROUBLESHOOTING
Trouble | Possible Cause | Remedy | |
The motors do not turn on | The power supply cable (21) is faulty or | Replace or connect the cable | |
disconnected from the electrical mains | |||
|
| ||
| The recovery water tank (26) is full | Empty | |
|
|
| |
| The vacuum grid (36) is clogged or the float | Clean the grid and check the float | |
| is closing | ||
|
| ||
| The vacuum hose (22) is disconnected from | Connect | |
| the squeegee (11) or it is damaged | ||
|
| ||
The dirty water vacuuming is insufficient | The squeegee (11) is dirty, or the squeegee | Clean the squeegee or replace the blades | |
| blades (13, 14) are worn or damaged |
| |
| The recovery water tank cover (6) is not | Check and/or clean the seating surface or | |
| properly closed, or the gasket (32) is | ||
| replace the gasket | ||
| damaged | ||
|
| ||
|
|
| |
| The recovery water tank (6) is dirty (clogged | Clean | |
| drain hole) | ||
|
| ||
The solution flow is insufficient | The solution filter (20) is dirty | Clean | |
| There is debris under the squeegee blades | Remove the debris | |
| (13, 14). | ||
The squeegee leaves marks on the floor |
| ||
The squeegee blades (13, 14) are worn, | Replace the blades | ||
| |||
| chipped or torn | ||
|
| ||
|
|
|
For further information refer to the Service Manual, available at any Nilfisk Alto Service Center.
SCRAPPING
Have the machine scrapped by a qualified scrapper.
Before scrapping the machine, remove and separate the following materials, which must be disposed of properly according to the Law in force:
–Brush
–Pad
–Electrical and electronic components (*)
(*)Refer to the nearest Nilfisk Alto Center especially when scrapping electrical and electronic components.
18
SCRUBTEC 343E | 909 6315 |