ENGLISH | USER MANUAL |
|
|
|
|
MAINTENANCE
The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance.
The following chart provides the scheduled maintenance. The intervals shown may vary according to particular working conditions, which are to be defined by the person in charge of the maintenance.
WARNING!
Maintenance procedures must be performed with the machine switched off and the power supply cable disconnected from the electrical mains.
Moreover, carefully read the instructions in the Safety chapter.
All scheduled or extraordinary maintenance procedures must be performed by qualified personnel, or by an authorised Service Center.
This Manual describes only the easier and most common maintenance procedures.
NOTE
For other maintenance procedures shown in the Scheduled Maintenance Table, refer to the Service Manual that can be consulted at any Service Center.
SCHEDULED MAINTENANCE TABLE
Procedure | Daily, after using | Weekly | Every six | Yearly | |
the machine | months | ||||
|
|
| |||
|
|
|
|
| |
Squeegee cleaning |
|
|
|
| |
Brush cleaning |
|
|
|
| |
Tank and vacuum grid cleaning |
|
|
|
| |
|
|
|
|
| |
Squeegee blade check and replacement |
|
|
|
| |
Solution filter cleaning |
|
|
|
| |
Screw and nut tightening check |
|
| (1) |
| |
|
|
|
|
| |
Vacuum system motor carbon brush check and replacement |
|
|
| (2) | |
|
|
|
|
|
(1)And after the first 8 working hours.
(2)This maintenance procedure must be performed by Nilfisk Alto authorised Service Center.
14
SCRUBTEC 343E | 909 6315 |
