USER MANUAL
ENGLISH
MACHINE START AND STOP
Starting the machine
1.Prepare the machine as shown in the previous paragraph.
2.Drive the machine to the working place by pushing it with the hands on the handlebar (2).
3.Connect the power supply cable (21) to the electrical mains.
WARNING!
Before connecting the power supply cable to the electrical mains, check that frequency and voltage, shown on the machine serial number plate (1), match the electrical mains voltage.
4.Lower the squeegee (11) with the lever (19).
5.Turn the solution flow control lever (4) to a position between the minimum limit (5a) and maximum limit (5b). In no case it is possible to close completely the water flow to the brushes during operation.
6.While keeping the hand on the handlebar (2), start the machine by turning the
Stopping the machine
7.Turn the
8.Disconnect the power supply cable (21) from the electrical mains.
9.Lift the squeegee with the lever (19).
10.Insert the positioning pin (24) and lift the
MACHINE OPERATION (SCRUBBING/DRYING)
1.Start the machine as shown in the previous paragraph.
2.While keeping both hands on the handlebar (2), move the machine and start scrubbing/drying the floor.
CAUTION!
To avoid damaging the floor surface, do not use the brushes without the solution and, when the machine is not operating, stop the
CAUTION!
Before lifting the brush/pad, turn it off by pressing the switch (52).
3.If necessary, adjust the solution quantity by using the lever (4).
NOTE
For correct scrubbing/drying of floors at the sides of the walls, Nilfisk Alto suggests to go near the walls with the right side of the machine as shown in figure 1.
A |
B |
Figure 1
P100160
Machine speed adjustment
4.The machine speed varies according to the type of floor to be cleaned and the choice of using the brush or the pad. If necessary, it is possible to adjust the machine speed, according to the procedure shown in Maintenance chapter.
909 6315 | SCRUBTEC 343E |
11