OPERATION - FONCTIONNEMENT - FUNCIONAMIENTO
CHANGING THE
EXHAUST FILTER
The electrostatic exhaust filter catches any particles that may escape from the filter bag, vacuum inlet filter, or lower motor filter. The electrostatic exhaust filter is located under the external front grill. Replace the filter every fourth time you change the bag.
To replace the electrostatic filter release the external grill and replace the exhaust filter with a new original one.
Never operate the vacuum without the Exhaust Filter in place.
HEPA FILTER (Optional)
This special filter assures 99.97% filtration efficiency at
0.3micron for the ultimate in air filtration in the most critical applications. It can be placed under the dust bag instead of the motor protection filter.
Change the Hepa filter every 8 bags or more often if it is in a very dusty environment. If the paper bag should break, the Hepa filter must also be replaced.
CHANGING THE BRUSH ROLLER
1.Lay the machine over onto its left side.
2.Slide the side cover off the end of the brush (reuse on new brush).
3.Grasp the center of the brush by bristles and pull it up and out the right side of the housing. Remove the brush support, it will be reused.
REMPLACEMENT DU FILTRE ELECTROSTATIQUE
Ce filtre retient les particules fines qui s’échappent d’autres filtres et evite toute fuite de
Pour changer le microfiltre, enlever la grille externe et le remplacer par un nouveau original.
Ne jamais utiliser la machine sans le filtre électrostatique.
HEPA FILTER (Optionel)
Ce filtre spécial assure le 99,97% d’efficacité filtrante à 0,3 microns et il est conçu pour les applications les plus critiques. Il peut etre placé sous le sachet au lieu du filtre protection moteur.
Remplacer le filtre Hepa tout les 8 sacs ou plus souvent pour les endroits plus sales.En cas de rupture du sac, remplacer aussi le filtre Hepa.
CHANGEMENT DE
BROSSE
1.Coucher la machine sur le côté gauche.
2.Faire coulisser le couvercle latéral hors du boîtier de la brosse.
3.Extraire délicatement le support du rouleau de l’extrémité de la brosse (réutiliser sur une brosse neuve).
SUSTITUCIÓN DEL FILTRO ELECTROSTATICO
El filtro electrostático coge cualquier partícula que pueda escapar de otros filtros, también el micropolvo producido por el motor. El microfiltro está situado debajo del la rejilla exterior. Substituir el filtro cada 4 bolsas que use.
Para sustituir el microfiltro quitar la rejilla exterior y sustituirlo con un nuevo original.
Nunca debe de utilizar el aparato sin un filtro electrostático Lindhaus.
FILTRO HEPA (Opcional)
Este filtro asegura un filtrado eficiente del 99,97% a 0,3 micrones y se adapta a las aplicaciones más críticas.Puede ser applicado debajo de la bolsa en luego del filtro proteccion motor.
Sustituir el filtro Hepa cada 8 bolsasEn caso de rotura de la bolsa, el Filtro Hepa también necesita ser sostituido. La duración máxima del Filtro Hepa es de 8 bolsas.
SUSTITUCIÓN DEL RODILLO
1.Poner la máquina a yacer sobre el lado izquierdo.1.
2.Quitar la porta lateral del hueco del cepillo.
3.Sacar el soporte del rodillo de la extremidad del cepillo (el soporte será reutilizado para el cepillo nuevo).
Nobles UltraGlide | 13 |