Nilfisk-ALTO 91WS manual Machine Controls Key Switch, Gas/LP Powered Machines, Hour Meter

MACHINE CONTROLS

C0602 FIGURE 3

MACHINE CONTROLS

KEY SWITCH

The key switch is a two position rotary ON/OFF switch that is located on the control panel.

The filter shaker will activate for 20 seconds after the key switch is turned to the “OFF” position unless equipped with the optional filter shaker switch.

Gas/LP Powered Machines

The key switch must be turned “ON” before using the electric starter button or the pull start. -Turn the key switch to the “ON” position before using the start button.

-Turn the key switch to the “OFF” position to turn off the sweeper.

Battery Powered Machines

To conserve battery power turn the key switch “OFF” when leaving the machine unattended even if only for a minute. Run time for the battery powered machine can vary with operating conditions and machine maintenance practices.

-Turn the key switch to the “ON” position to turn on the sweeper. -Turn the key switch to the “OFF” position to turn off the sweeper.

BATTERY CONDITION METER (Battery Powered Machines)

The battery condition meter is located on the left side of the console. The condition meter indicates the level of charge in the batteries. The batteries are sufficiently charged when the needle stays in the green area on the gauge while the machine is being operated. Charge the batteries when the needle drops into the red zone while operating the machine.

WARNING

Do not operate the machine if the needle stays in the red zone. Operating the sweeper with discharged batteries

will degrade battery life.

HOUR METER

The Hour Meter is located on right side of the console. The meter is activated when the key switch is on. The meter indicates actual run time of the sweeper. The meter is used to determine when maintenance should be performed.

American-Lincoln	1 - 9
91 WS