Nilfisk-ALTO 91WS manual Machine Controls, Circuit Breakers, Rewind Starter

MACHINE CONTROLS

12	14	CHOKE		OFF ON	START
10	16
	BATTERY					HOURS
					0	0	0	0	0
		CB-1	CB-2	FILTER SHAKER
					OFF
C-1161	CIRCUIT
	BREAKERS
C1161		FIGURE 11

CIRCUIT BREAKERS

The circuit breakers provide protection for the electrical system and are located on the console. The circuit breaker “POPS” out when an overcurrent condition exists.

When a circuit breaker pops out, the machine must be taken out of service and repaired before the circuit breaker will reset. The circuit breaker may be reset when the overcurrent condition has been corrected.

Push the button in to reset a popped circuit breaker.

REWIND STARTER

The Gas/LP engine is equipped with a rewind starter. If the battery is dead, it may be possible to start the engine with the rewind starter.

Open the top cover to gain access to the rewind starter.

To use the rewind starter:

-Turn key switch to “On” position.

-Grasp the starter, and pull it slowly until the starter en- gages.

P4550	FIGURE 12	-Pull the cord rapidly enough to overcome compression,
		prevent kickback and start engine.

American-Lincoln	1 - 13
91 WS