OPERATING INSTRUCTIONS
STARTING INSTRUCTIONS
Before starting the machine, do these
1.Check all controls for proper operation.
2.Check for loose battery connections.
3.Make sure all controls are “OFF”.
4.Check to be certain that the forward /reverse control handle is centered in the neutral position.
TO START THE BATTERY POWERED SWEEPER
Perform the
1.Turn the key switch to the “ON” position.
2.Check the battery condition meter after the machine is on to determine if battery is sufficiently charged. Charge the batteries when the needle stays in the red zone while the machine is being operated
TO START GAS POWERED SWEEPER
Follow these instructions for starting a cold engine. If the engine is warm reduce the initial choke setting in step 1 to halfway out position.
1.Set the choke to the full out position.
2.Turn the key switch to the “ON” position.
3.Push the start button until the engine starts. Do not hold the start button for more than 15 seconds at a time.
4.After engine starts, gradually push in the choke until the engine runs smoothly.
5.If the engine starts then stalls push in the choke halfway and restart the engine.
6.At temperatures below 50° F (10° C), a one or two minute
7.Push the choke control all the way in when the engine reaches normal operating temperature.
TO START LP POWERED SWEEPER
Follow these instructions for starting a cold engine. If the engine is warm reduce the initial choke setting in step 4 to halfway out position.
1.Open the LP storage tank valve.
2.Check all propane components for leaks and physical security. Be sure the tank is securely fastened.
3.Check the regulator. Momentarily press fuel primer on the regulator cover to bleed air out of the system.
4.Set the choke to the full out position.
5.Push the start button until the engine starts. Do not hold the start button for more than 15 seconds at a time.
6.If the engine starts then stalls, push in the choke halfway and restart the engine.
7. | At temperatures below 50° F (10° C), aone or two minute | may be required. |
8. | Push the choke control all the way in when the engine reaches normal operating temperature. | |
TO START ENGINE USING THE REWIND STARTER
The Gas/LP engine is equipped with a rewind starter. If the battery is dead, it may be possible to start the engine with the rewind starter. Grasp the starter, and pull it slowly until the starter engages. Pull the cord rapidly enough to overcome compression, prevent kickback and start engine. Repeat if necessary with the choke opened slightly. When the engine starts open the choke gradually to position that allows the engine to run smoothly.
1 - 15 | |
91 WS |
|
