Nilfisk-ALTO SR 1450 B-D manuel dutilisation Drive direct current motor SR 1450 B, User Manual

USER MANUAL

	Every 10	After 50	Every 150	Every 300	Every 500	Every	Every
Maintenance						1,000	2,000
	hours	hours	hours	hours	hours
						hours	hours
Oil filter element replacement
Fuel filter element replacement
Hydrostatic pump hydraulic oil filter replacement
Fuel screw and fitting tightening
Injector check
Glow plug check
Engine air cleaner replacement
Fuel tank cleaning
Alternator belt replacement
Hydraulic oil change
Starter brush replacement
Hydraulic motor and pump pressure check
Sealing gasket wear check
Brake system check
Moving part clearance check

Drive direct current motor (SR 1450 B)

		Every 150	Every 200	Every 400	Every 6	Every	Every time
	Maintenance						a check is
		hours	hours	hours	months	year
							carried out
Commutator	Ensure that the surface along which the carbon
	brushes slide is covered with an even, shiny,
	transparent light grey film.
	Check that there are no black marks or burns
	between the commutator segments and on the
	commutator outer crown.
	Ensure that the commutator surface is not lined,
	deeply grooved or burnt on the segment in or out
	edges.
	Check that the brooms have not grooved the
	commutator surface and that the insulating mica
	does not protrude from the copper segment.
	Check that the commutator is clean and that there
	are no burns on the segments; if necessary, clean
	the commutator as described.
	Check eccentricity.
	Clean the commutator with special rubber sticks. If
	necessary, clean between the segments.

16 33014811(1)2005-07 A