Wireless modem setup for Nokia 6360 phone
2Connect the
3Click Start, point to Settings, then click Control Panel.
4Double click the Modems or Phone and Modem Options control panel icon.
5Click Add. (Windows 2000 users, please click the Modems tab, then click Add).
6Select the Do not detect my modem... option, then click Next.
7Click Other if asked about a PCMCIA modem (this screen may not appear on all systems), then click Next.
8Insert the floppy diskette containing the .inf file in your drive now. Click the Have Disk button. Confirm that A:\ is the location of the nok_tdma.inf file, then click OK.
9Select Nokia 6360 via Cable from the list of available choices, then click Next.
10Select the COM port where the cable is attached (typically COM1), then click Next.
11The Wizard indicates it has located the correct software for your phone. Click Finish when Windows informs you that it has installed the device successfully.
12Verify that your Nokia phone connected using the
Complete the process by configuring your data software to work with the new infrared modem configuration. For more information, refer to “Configure your data and fax software” on page 29.
• GETTING CONNECTED FOR THE FIRST TIME USING IR (WINDOWS 95, 98, AND ME)
Before you can make or receive digital data and fax calls, you must do the following:
1Establish an infrared connection between your PC and your phone.
2Install your phone as a wireless modem connected via infrared.
3Configure your data software to use your phone as the active modem for data and fax calls.
Establish an infrared connection
The preferable distance between the two devices making an infrared connection is a range of three inches (7.5 cm) to three feet (.9 m) maximum. There must be no obstructions between the two devices, and the IR ports of the two devices must be pointing at each other.
ENABLE INFRARED COMMUNICATIONS ON YOUR PC AND PHONE
1
If this icon does not appear in the Control Panel, see “Install infrared support for Windows 95” on page 28.
Tip: Windows 98 users can also launch the Infrared Monitor by
2Click the Options tab, then select Enable infrared communication. Verify that the install software option for Plug and Play devices is selected.
3Click Apply, then click the Status tab.
4On your phone, press Menu, scroll to Infrared, then press Select.
5Align the infrared ports of both devices.
6When a successful infrared connection has been made, the infrared monitor indicates that your phone has been found.
8
[ 26 ]
