INSTALLATION OF THE MEDIAMASTER
Connecting a satellite receiver and a VCR
•Connect a SCART cable between the main SCART socket on the TV and the TV SCART socket on the Mediamaster.
•Connect a SCART cable between the VCR and the AUX SCART socket on the Mediamaster.
•Connect an RF cable from the RF output on the VCR to the TV aerial input on the TV.
•Connect an RF cable from the RF output on the satellite re- ceiver to the RF input socket on the VCR.
•Connect the TV aerial to the RF input socket on the satellite receiver.
In order to switch the signal from the dish between the satel- lite and digital receivers, you need a Nokia smart switch (at A B in the diagram) or a Universal Twin LNB.
With Nokia smart switch
VCR
RF
Media-
SCARTmaster
Satellite receiver
Nokia smart switch
• Connect a coaxial cable between output A on the smart switch (accessory) to the LNB socket on the satellite receiver.
• Connect a coaxial cable between output B on the smart switch
to the ANTENNA socket on the Mediamaster. |
|
The satellite receiver must be switched OFF (in standby | Nokia smart switch |
mode) when you want to watch digital satellite channels |
|
from the Mediamaster. |
|
Connecting a HiFi system
•Connect an RCA/Cinch stereo cable from the AUDIO L R sock- ets on the Mediamaster to the LINE, AUX, SPARE or EXTRA input sockets on your HiFi system.
•If available you can connect an RCA/Cinch single cable from the DIGITAL AUDIO socket on the Mediamaster to your HiFi or Dolby Pro Logic system.
Note: To avoid interference you must use a screened audio cable.
Connecting to the built in phone modem
The built in phone modem makes it possible for you to use inter- active services. Refer to page 38.
•Connect the attached telephone cable between the socket marked TELEPHONE on the rear of the Mediamaster and the ordinary telephone socket in the wall.
GB 10
