PROBLEM SOLVING
Problem | Possible causes | What to do |
The display on the front panel does | Mains cable is not connected. |
not light up/is not lit. |
|
Check that the mains cable is plugged into the power socket.
No sound or picture, but the front panel shows the time or -
The Mediamaster is in standby mode.
Press the standby button or any number button to bring the Media- master out of standby mode.
No sound or picture. | The satellite dish is not pointing |
| at the satellite. |
| No signal or weak signal. |
No sound or picture on horizontal | The LNB is faulty. |
| |
modulated transponder. |
|
Adjust the dish. Check the signal level indicator in one of the channel search submenus.
Check the cable connections, LNB and other equipment connected be- tween the LNB and the receiver, or adjust the dish.
Replace the LNB.
Increase the LNB voltage with 0,5 V from the System Configuration menu if you have a long cable.
Bad picture/blocking error. | The satellite dish is not pointing | Adjust the dish. |
| at the satellite. |
|
| Signal too strong. | Connect a signal attenuator to the |
|
| LNB input. |
| Satellite dish is too small. | Change to a larger dish. |
| LNB noise factor too high. | Change to an LNB with lower noise |
|
| factor. |
| The LNB is faulty. | Change the LNB. |
|
|
|
There is no Welcome menu on the screen after you switched on the Mediamaster for the first time.
The system is connected by SCART cables and the TV is not in AV/EXT mode.
The system is connected by RF ca- bles and the TV is not set to the channel tuned for satellite TV.
If the system is connected by SCART cables, switch the TV to the appropriate AV input.
If the system is connected by RF cables, switch the TV to the chan- nel for satellite TV. If you have not tuned in the TV you may do this first. Please look in the TV manual for instructions. You can also change the
There is interference on your digital satellite channels, an existing ter- restrial channel or video signal.
The system is connected by RF ca- bles and the output channel of the
Change the Mediamaster output channel to a more suitable channel between
You made a video recording of a sat- ellite channel but the programme was not recorded.
The system is connected by SCART cables and the VCR is not in AV/EXT mode.
The system is connected by RF ca- bles and the VCR is not set to the channel tuned for satellite TV.
If the system is connected by SCART cables, switch the VCR to appropriate AV input.
If the system is connected by RF cables, switch the VCR to the chan- nel for satellite TV. If you have not tuned in the VCR you may do this first. Please look in the VCR manual for instructions.
GB 46
