MAIN MENU
Antenna/Satellite configuration
Set up and adjust motor
The procedure is the same as performed during the First Time In- stallation. Please refer to page 20.
East/West limit setup
You only have to set one or both of these limits if the antenna is prevented from reaching its East/West limit positions. This could be the case e.g. if the antenna is mounted to close to a wall or in any similar situation.
•To set these limits, select East or West limit setup and press OK.
•Adjust the antenna using the 
buttons.
Watch the antenna movement, and when it has reached its pos- sible limit, press OK. The other limit is set in the same way (if needed).
Reset limits
In case you need to reset limits.
When you perform this command you do not just reset the lim- its. The motor will also turn itself to the 0° (Zero) position. How- ever, next time you select a channel the motor will turn to its proper position.
TV settings
TV screen format
Select your TV screen format.
The 4:3 format is the standard format for most TV screens. Select 16:9 for a wide screen TV.
TV signal
If the teletext function does not work when watching channels from an analogue satellite receiver connected to the Media- master, change this setting from RGB to PAL.
RF channel
Select this alternative if you have to change the RF channel.
If you change the RF channel number, you must also change it to the same value on the TV. If you do not, the picture will become black.
RF modulator type
If the Mediamaster is connected to the TV by an RF cable, you can select the RF modulator type. The RF modulator affects a channel’s audio. If you get picture but no sound, the RF modula- tor selection might be wrong.
Select “Normal (PAL B/G)” for all countries except the UK.
Select “UK (PAL I)” when the box is used in the UK. | ➝ |
The RF channel number will be in- dicated on the front display of the Mediamaster.
GB 37
