Moxa Technologies G2150I Restore Factory Settings &F, Display Configuration &V, Cancellation

OnCell G2150I AT Command Set V24-V25 Commands

Restore Factory Settings: &F

Description: This command is used to restore the factory settings from EEPROM. It only restores the parameters that can be found in paragraph 19 Codes and values (Parameters Storage paragraph) with AT&F column checked. Those parameters are restored in RAM and in E2P, overwriting the profile set with AT&W.

Command syntax: AT&F[<n>]

Command	Possible responses
AT&F	OK
Note: Ask to restore the factory settings	Note: Done
AT&F0	OK
Note: idem	Note: Done

Defined values: <n>

0:restore factory setting No other value supported

Display Configuration: &V

Description: This command is used to display the modem configuration.

Command syntax:	AT&V<n>
The parameters displayed are the following:
	Q:val1, V:val2, S0:val3, S2:val4, S3:val5, S4:val6, S5:val7,
	+CR:val8, +CRC:val9, +CMEE:val10, +CBST:val11,
	+SPEAKER:val12, +ECHO:val13, &C:val14, &D:val15, %C:val16
	+IPR:val17, +ICF:val18, +IFC:val19
Command		Possible responses
AT&V		Q:0 V:1 S0:000 S2:043 S3:013 S4:010 S5:008
Note: Display active parameters in RAM		+CR:0 +CRC:0 +CMEE:0 +CBST:0,0,1
		+SPEAKER:0 +ECHO:0,0 &C:1 &D:2 %C:0
		+IPR:9600 +ICF:3,4 +IFC:2,2
		OK
		Note: Done
		For Echo the first value corresponds to Echo
		cancellation 1.

Defined values: <n>

0Display the modem configuration in RAM (default value if no parameter provided)

1Display the modem configuration in EEPROM

2Display the modem factory configuration.

9-8