Moxa Technologies G2150I manual Request Revision Identification +CGMR, Product Serial Number +CGSN

OnCell G2150I AT Command Set General Commands

Request Revision Identification: +CGMR

Description: This command is used to get the revised software version. This function only applies to default IP addresses.

Command syntax: AT+CGMR

Command	Possible responses
AT+CGMR	657_09gg.02406B 2015268 100506 17:01
	OK
Note: Get software version	Note: Software release 6.57, generated on the 5th of October
	2006
Defined values: No parameters

Product Serial Number: +CGSN

Description: This command allows the user application to get the product’s IMEI (International Mobile Equipment Identity, a 15 digit number).

Command syntax: AT+CGSN

Command	Possible responses
AT+CGSN	012345678901234
Note: Get the IMEI	OK
	Note: IMEI read from EEPROM
AT+CGSN	+CME ERROR: 22
Note: Get the IMEI	Note: IMEI not found in EERPROM

Defined values: No parameter

Select TE Character Set: +CSCS

Description: This command informs the ME which character set is used by the TE. The ME can convert each character of entered or displayed strings. This is used to send, read or write short messages. See also +WPCS for the phonebooks’ character sets.

Command syntax: AT+CSGS =<Character Set>

Command		Possible responses
AT+CSCS=“GSM”		OK
Note: GSM default alphabet		Note: Command valid
AT+CSCS=“PCCP437”		OK
Note: PC character set code page 437		Note: Command valid
AT+CSCS=?		+CSCS:
		(“GSM”,”PCCP437”,”CUSTOM”,”HEX”)
Note: Get possible values		OK
		Note: Possible values
Defined values:	<Character Set>
“GSM”	GSM default alphabet.
“PCCP437”	PC character set code page 437.
“CUSTOM”	User defined character set (cf. +WCCS command).
“HEX”	Hexadecimal mode. No character set used; the user can read or write
	hexadecimal values.
	3-3