Moxa Technologies G2150I manual Capabilities List +GCAP, Repeat Last Command a, Power Off +CPOF

OnCell G2150I AT Command Set General Commands

AT+CCID=?

Note: Get possible value

OK

Note: No parameter but this command is valid

Note: if there is no EF-CCID file present on the SIM, the +CCID answer will not be sent, but the OK message will be returned.

Defined values: No parameter

Capabilities List: +GCAP

Description: This command gets the complete list of capabilities.

Command syntax: AT+GCAP

Command	Possible responses
AT+GCAP	+GCAP: +CGSM, +FCLASS
Note: Get capabilities list	OK
	Note: Supports GSM and FAX commands

Defined values: No parameter

Repeat Last Command: A/

Description: This command repeats the previous command. Only the A/ command itself cannot be repeated.

Command syntax: A/

Command Possible responses

A/

Note: Repeat last command

Defined values: No parameter

Power Off: +CPOF

Description: This specific command stops the GSM software stack as well as the hardware layer, or the G2150I activity. The AT+CFUN=0 command is equivalent to +CPOF.

Command syntax: Command syntax: AT+CPOF[=1]

Command	Possible responses
AT+CPOF	OK
Note: Stop GSM stack	Note: Command valid
AT+CPOF=1	OK
Note: Stop the Wireless CPU	Note: Command valid

Note: After AT+CPOF=1, the G2150I will not respond to AT commands. To reset it, use the hard reset.

Note: In autobaud mode, after an AT+CPOF, unsolicited information waking up the G2150I is sent at 9600 bps until an AT command is sent. When an AT command is sent, the G2150I will synchronize with the sender’s speed. (see CAUTION in § 14.1.1)

Defined values: No parameter

Set Phone Functionality: +CFUN

Description: This command selects the mobile station’s level of functionality. When the application wants to stop the product with a power off, or if the application wants to force the product to execute an IMSI DETACH procedure, then it must send: AT+CFUN=0 (equivalent to

3-5