Moxa Technologies G2150I manual DTE-DCE Character Framing +ICF, DTE-DCE Local Flow Control +IFCR

OnCell G2150I AT Command Set V24-V25 Commands

DTE-DCE Character Framing: +ICF

Description: This command is used to determine the local serial port start-stop (asynchronous) character framing used by the DCE.

Command syntax: AT+ICF= <format>[, <parity>]

Command	Possible responses
AT+ICF?	+ICF: 3,4
	OK
	Note: Current values
AT+ICF=?	+ICF: (1-6),(0-4) OK
	Note: Possible values
AT+ICF=2,0	OK
	Note: New values

Defined values: <format>

0:Auto detect (not supported)

1:8 Data 2 Stop (supported) <parity> parameter is ignored.

2:8 Data 1 Parity 1 Stop (supported) if no <parity> provided

3:is used by default as <parity> value. 3: 8 Data 1 Stop (supported) <parity> parameter is ignored.

4:7 Data 2 Stop (supported) <parity> parameter is ignored.

5:7 Data 1 Parity 1 Stop (supported) if no <parity> provided, 3 is used by default as <parity> value.

6:7 Data 1 Stop (supported) <parity> parameter is ignored.

<parity>

0:Odd (supported)

1:Even (supported)

2:Mark (supported)

3:Space (supported)

4:None (supported)

Notes:

•Setting a character framing different from 8N1 will disable autobauding if it was activated. Setting it back to 8N1 will not re-enable auto-baud.

•Setting the framing to 8N1 will let autobauding be enabled, if it was already enabled (implying framing was already 8N1).

DTE-DCE Local Flow Control: +IFCR

Description: This command is used to control the operation of local flow control between the DTE and DCE.

Command syntax:	AT+IFC=<DCE_by_DTE>,<DTE_by_DCE>
Command		Possible responses
AT+IFC?		+IFC: 2,2
		OK
		Note: Current values
AT+IFC=?		+IFC: (0,2),(0,2) OK
		Note: Possible values
	9-3