Moxa Technologies G2150I manual Hang-Up Command H, Used and 10 locations are available

OnCell G2150I AT Command Set		Call Control Commands
	Command	Possible responses
	AT+CPBS?	+CPBS:”SM”,8,10
	Note: Which phonebook is selected?	Note: ADN phonebook is selected, 8 locations are
		used and 10 locations are available
	ATD>SM6;	OK
	Note: Call index 6 from ADN phonebook	Note: Call succeeds

When the FDN phonebook has been locked, only numbers beginning with the digits of FDN phonebook entries can be called. For example, if “014629” is entered in the FDN phonebook all the phone numbers beginning with these 6 digits can be called. The CLIR supplementary service subscription can be overridden for this call only.

“I” means “invocation” (restrict CLI presentation). “i” means “suppression” (allow CLI presentation).

Control of CUG supplementary service information by “G” or “g” is allowed for this call only. The index and info values set with the +CCUG command are used. An outgoing call attempt could be refused if the AOC service is active and credit has expired (NO CARRIER). When trying to set up an outgoing call while there is an active call, the active call is first put on hold, then the call set up is carried out. As per GSM 02.30, GSM sequences may be controlled using dial commands. These sequences can contain “*”, “#”, but “;” is forbidden. If the sequence is not supported or fails, +CME ERROR: <err> is returned. In the case where the FDN phonebook is activated, the sequence concerning call forwarding are allowed only if there are written in the FDN. See paragraph 19 Codes and values to have the list of supported sequences.

Command	Possible responses
ATD*#21#	+CCFC: 0,7
Note: Check any call forwarding status	Note: No call forwarding
ATD**61*+33146290800**25#	OK
Note: Register call forwarding on no reply, with	Note: done
no reply timer fixed at 25 s.
ATD*2#	+CME ERROR 3
Note: Bad sequence

Defined values:

<nb> destination phone number

<I> (optional parameter) “I” means “invocation” (restrict CLI presentation). “i” means “suppression” (allow CLI presentation).

<mem> phonebook (one of “SM”,”LD”,”MC”,”ON”,”ME”,”RC”,”MT” or “SN”). A default value can be selected by +CPBS command.

<index> call number at indicated offset from the phonebook selected by the +CPBS command <name> call number corresponding to given name from the phonebook selected by the +CPBS command

Hang-Up Command: H

Description: The ATH (or ATH0) command is used by the application to disconnect the remote user. In the case of multiple calls, all calls are released (active, on-hold and waiting calls). The specific G2150I ATH1 command has been appended to disconnect the current outgoing call, only in dialing or alerting state (i.e. ATH1 can be used only after the ATD command, and before its terminal response (OK, NO CARRIER, ...). It can be useful in the case of multiple calls.

Command syntax: ATH<n>

4-3