Moxa Technologies G2150I manual Gprs Parameter Customization + Wgprs, Context, 10-19

OnCell G2150I AT Command Set GPRS Commands

GPRS Parameter Customization: + WGPRS

Description: This command modifies some G2150I GPRS parameters:

‧the ATTACH-STATUS (the ME does or not perform automatically a GPRS attachment after initialization),

‧the PDP-INIT-STATUS (activates automatically or not some defined PDP contexts after initialization) and

‧the user-defined multislot class. This parameter represents the GPRS class chosen by

the user to perform power saving (by reducing TX (or uplink) time slots). In addition, this command allows:

‧set automatically “ACTIVABLE” some defined PDP contexts after initialization

‧set some parameters for PALM® OS software: PPP Silent Mode (PPP waits for PPP Client to start the dialog) and Slow CONNECT (due to the delay of the processing of PALM® OK, the CONNECT is sent one second after the dialing command

request)

IMPORTANT NOTE: The G2150I must be rebooted to activate the new setup except for <mode> 3, 5, 6 and 7 (please refer to Defined Values paragraph).

Command syntax: AT+WGPRS=<mode>,<parameter>,[<cid>],[<class>]

Command	Possible responses
AT+WGPRS=?	+WGPRS: <mode>,
	<parameter1>,[<cid>]
	[<CR><LF>+WGPRS:
	<mode>,
	<parameter>,[<cid>]
	[...]]
	OK
AT+WGPRS?	+WGPRS:<mode>(list of supported
	<parameter>),[(list of
	supported
	<cid>)][<CR><LF>+WGPR
	S:<mode>(list of
	supported
	<parameter>),[(list of
	supported <cid>)] [...]]
	OK
AT+WGPRS=2,1,3	OK
Note: set ACTIVABLE to ON on PDP
context 3
AT+WGPRS=7,1	OK
Note: set automatic re-attachment to the
network and reactivation of PDP context
in case of change of operator for
MCC/MNC
AT+WGPRS=4,,,8	OK
Note: choose GPRS multislot class 8
AT+WGPRS=?	+WGPRS: (0-7),(0-1),(0-
Note: Request ranges of values	4),(2,8,10, 12)
	OK

10-19