Moxa Technologies G2150I manual AT+WOPN=3,0, Memory, AT+WOPN=4, Used for Plmn names

OnCell G2150I AT Command Set		Network Service Commands
	AT+WOPN=0,99999	+CME ERROR: 22
	Note: Give a wrong operator	Note: Not found
	AT+WOPN=0,20801,36	+WOPN: 0,”Orange F”
	Note: Give an operator in numeric format for lac	OK
	36	Note: Alphanumeric answer
	AT+WOPN=3,0	OK
	Note: Erase NITZ PLMN names stored in flash
	memory
	AT+WOPN=4	+WOPN: 31
	Note: Read from EEPROM which method will be	OK
	used for PLMN names.
	AT+WOPN=4,<PlmnOns>	OK
	Note: Write to EEPROM which method will be
	used for PLMN names.
	Defined values:
	<mode> 0 Use long alphanumeric format

1 Use short alphanumeric format

2 Reserved for later use

3 Erase NITZ PLMN list if <NumOper> = 0

4 Access to EEPROM to read or write the method used for getting PLMN names. Read access if <NumOper> omitted, write access if <NumOper>(=<PlmnOns>) provided.

<NumOper> is the operator in numeric format.

<AlphaOper> is the operator in long or short alphanumeric format (see appendix 19 Codes and values for operator names description)

<lac> is the two bytes Location on Area Code to be used to get the PLMN name. If it is not entered, Current lac will be used (0 if limited service). It is provided as an integer

value.
<PlmnOns> is a bit-field with following coding:
bit 0 E-ONS
bit 1	CPHS
bit 2	SPN
bit 3	NITZ
	bit 4 FLASH
Bit 4 (FLASH)	Bit 3 (NITZ)	Bit 2 (SPN)	Bit 1 (CPHS)	Bit 0 (E-ONS)

Bit value is 1 for Activate and 0 for Deactivate the method. <PlmnOns> value should be provided as a decimal value.

1 1 1 1 1

Note: For example, <PlmnOns>=31 means that the four methods will be used for PLMN names (bit-field value is 1111 or 0x1F).

5-7