OnCell G2150I AT Command Set

General Commands

AT+CPOF). This command executes an IMSI DETACH and makes a backup copy of some internal parameters in SIM and in EEPROM. The SIM card cannot then be accessed. If the mobile equipment is not powered off by the application after this command has been sent, a re-start command (AT+CFUN=1) will have to issued to restart the whole GSM registration process. If the mobile equipment is turned off after this command, then a power on will automatically restart the whole GSM process. The AT+CFUN=1 command restarts the entire GSM stack and GSM functionality: a complete software reset is performed. All parameters are reset to their previous values if AT&W was not used. If you write entries in the phonebook (+CPBW) and then reset the product directly (AT+CFUN=1, with no previous AT+CFUN=0 command), some entries may not be written (the SIM task does not have enough time to write entries in the SIM card). In addition, the OK response will be sent at the last saved (AT&W) baud rate defined by the +IPR command. With the autobauding mode the response can be at a different baud rate. It is therefore preferable to save the defined baud rate with AT&W before directly sending the AT+CFUN=1 command.

Command syntax: AT+CFUN=<functionality level>

Command

Possible responses

AT+CFUN?

+CFUN: 1

Note: Ask for current functionality level

OK

Note: Full functionality

AT+CFUN=0

OK

Note: Set minimum functionality, IMSI detach

Note: Command valid

procedure

 

AT+CFUN=1

OK

Note: Set the full functionality mode with a

Note: Command valid

complete software reset

 

Defined values: <functionality level>

0:Set minimum functionality, IMSI detach procedure

1:Set the full functionality mode with a complete software reset

Phone Activity Status: +CPAS

Description: This command returns the activity status of the mobile equipment.

Command syntax: AT+CPAS

Command

Possible responses

AT+CPAS

+CPAS: <pas>

Note: Current activity status

OK

Defined values: <pas>

0 ready (allow commands from TA/TE)

1 unavailable (does not allow commands)

2unknown

3ringing (ringer is active)

4call in progress 5 asleep (low functionality)

3-6

Page 18
Image 18
Moxa Technologies G2150I manual Phone Activity Status +CPAS, Procedure, Complete software reset, Command syntax AT+CPAS