Moxa Technologies G2150I Automatic Answer ATS0, Incoming Call Bearer +CICB, Defined values mode

OnCell G2150I AT Command Set		Call Control Commands
	activated using +CLCK command). Voice call (with semi-colon).
AT%D1	Activates automatic DTR dialing if DTR switches from OFF to ON; Dials the
	phone number in the first location of the ADN phonebook (or FDN phonebook, if
	it is activated using +CLCK command). Data or Fax call (without semi-colon).
AT%D2	Activates automatic DTR short message transmission if DTR switches from OFF
	to ON. Sends the short message in the first location of the SIM.

If the first location is empty:

•AT%D1 and AT%D2 commands will receive an OK response

•The DTR ON event will trigger a CME ERROR: 21 or a CMS ERROR: 321.

Automatic Answer: ATS0

Description: This S0 parameter determines and controls the product automatic answering mode.

Command syntax: ATS0=<value>

Command	Possible responses
ATS0=2	OK
Note: Automatic answer after 2 rings
ATS0?	002
Note: Current value	OK
	Note: always 3 characters padded with zeros
ATS0=0	OK
Note: No automatic answer	Note: Command valid

All others S-parameters (S6,S7,S8 …) are not implemented. Defined values: <value>

number of rings before automatic answer (3 characters padded with zeros). Range of values is 0 to 255

Incoming Call Bearer: +CICB

Description: This specific command is used to set the type of incoming calls when no incoming bearer is given (see +CSNS).

Note: setting the +CICB command affects the current value of +CSNS.

Command syntax: AT+CICB=<mode>

Command	Possible responses
AT+CICB=1	OK
Note: If no incoming bearer, force a fax call	Note: Command accepted
AT+CICB=2	OK
Note: If no incoming bearer, force a voice call	Note: Command accepted
AT+CICB?	+CICB: 2
Note: Interrogate value	OK
	Note: Default incoming bearer: voice call
AT+CICB=?	+CICB: (0-2)
	OK
Note: Test command	Note: Speech, data or fax default incoming
	bearer

Defined values: <mode>

0:Data

1:Fax

2:Speech

4-7