Moxa Technologies G2150I manual Radio Link Protocol Parameters +CRLP, AT+ILRR=0 AT+ILRR=1 AT+ILRR?

OnCell G2150I AT Command Set		Data Commands
	Command syntax: AT+ILRR = <value>
	Command	Possible responses
	AT+ILRR=0	OK
	Note: Local port rate report disabled	Note: Command valid
	AT+ILRR=1	OK
	Note: Local port rate report enabled	Note: Command valid
	AT+ILRR?	+ILRR: 1
		OK
	AT+ILRR=?	+ILRR: (0,1) OK

Defined values:

<value>:

0:disable local port rate report

1:enable local port rate report

<rate> can take the following values: 300, 600, 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200 (kbps).

Radio Link Protocol Parameters: +CRLP

Description: This command modifies the radio link protocol parameters used for non transparent data transmission.

Command syntax: AT+CRLP= <iws>, <mws>, <T1>, <N2>, <ver>

Command	Possible responses
AT+CRLP=?	+CRLP: (0-61),(0-61),(40-255),(1,255),(0)
Note: Test command	OK
	Note: V42bis not supported
AT+CRLP=?	+CRLP: (0-61),(0-61),(40-255),(1,255),(0,1)
Note: Test command	OK
	Note: V42bis supported
AT+CRLP=61,61,48,6,0	OK
Note: Set new parameters	Note: Command valid
AT+CRLP?	+CRLP: 61,61,48,6,0
Note: Current values	Note: Command valid

Defined values:

<IWS>: Down window size, (default is 61) Range 0 to 61

<mws>: Up window size, (default is 61) Range 0 to 61

<T1>: Acknowledgement timer in units of 10 ms, (default is 48) Range 40 to 255

<N2>: Retransmission attempts, (default is 6), Range 1 to 255

<ver>: Version number.

0:V42bis is not supported.

1:V42bis is supported

8-5