5. Have another person hold the Console (4) near the

5

 

 

Handlebar (3).

Do not pinch

4

 

the wires during

Connect the Upper Wire Harness (42) to the wire har-

 

this step.

ness on the Console (4). Locate the two ground wires

 

 

 

that are connected with a screw to the Handlebar (3).

 

 

 

Connect the two ground wires to the two smallest wires

 

 

 

on the Console. Next, locate the two pulse wires

 

Ground

5

extending from the Handlebar. Connect each pulse

 

 

Wires

\

wire to the wire of the same color on the Console.

 

 

 

 

Snap the Handlebar Cover (5) onto the Handlebar (3).

 

 

 

Carefully insert all excess wires into the Console (4).

 

 

 

Attach the Console to the metal plate on the Handlebar

 

 

 

(3) with four M4 x 16ram Screws (57). Be careful to

 

 

Wires

avoid pinching the wires.

 

 

6.Tum the Seat Post Knob (20) counterclockwisetwo or three turns to loosen it. Next, pull the Knob, raise the Seat Post (8) a few inches, and then release the Knob.

Move the Seat Post up and down slightly until the

pin on the Knob snaps into one of the holes in the Seat Post. Then, turn the Knob clockwiseuntil it is

tight.

Attach the Seat Bracket (7) to the Seat Post (8) with two M8 x 25mm Patch Screws (59). Make sure that the Seat Bracket is oriented so the slot is on the indicated side.

\

7.Attach the Seat (9) to the Seat Carriage (11) with four M8 Nylon Locknuts (63) and four M8 Split Washers (55). Note: The Nylon Locknuts and Split Washers may be pre-attached to the underside of the Seat.

Slide the Seat Carriage (11) into the Seat Bracket (7).

7\

 

Move the Seat to the desired position. Insert the Seat

 

Knob (10) into the slot in the side of the Seat Bracket,

 

and tighten the Seat Knob into the Seat Carriage.

 

\

6

Page 6
Image 6
NordicTrack NTC59020 user manual Do not pinch, Wires during, Extending from the Handlebar. Connect each pulse