NordicTrack NTL11920 user manual Be careful not to pinch the Wires, Do not tighten the Bolts yet

4. Have a second person hold the Handrails (66) near the		4
Uprights (69) as shown. Connect the Upright Wire
Harness (98) to the wires extending from the Console
Base (81). Insert the connectors and the Upright Wire			81
Harness into the hole in the right Upright.
Set the Handrails (66) on the Uprights (69), being careful			98
not to pinch the Upright Wire Harness (98).
				69
		66
5. Insert two Handrail Bolts (78) with Handrail Spacers		5
(77) into the right Upright (69) and the right Handrail
(66). Be careful not to pinch the Wires.		Make sure
that the Handrail Spacers are flush against the right
Upright with the thick sides facing the center of the
treadmill, as shown in the inset drawing. Next, lift the			69
right Handrail (66) slightly and align the Bolts with the
holes in the Handrail. Thread the Bolts into the		66	77	Thick
Handrail.	Do not tighten the Bolts yet.
				Side
Attach the left Handrail (not shown) in the same way.
Tighten all four Handrail Bolts (78).		77	78

6. Make sure that all parts are properly tightened before you use the treadmill.		Note: If there is a thin sheet
of clear plastic on the hood decal, remove it. K	eep the included allen wrench in a secure place. The allen
wrench is used to adjust the walking belt (see page 27). To protect the floor or carpet from damage, place a
mat under the treadmill.

7