Nortel Networks 2700 manual Understanding the LEDs, Front panel LEDs, Front panel LED indicators

40Chapter 2 Cabling the VPN Router and turning the power on

Understanding the LEDs

This section describes the LEDs on the front panel of the VPN Router 2700 and on the interface cards that have LEDs. You can confirm that the LAN and WAN interfaces are cabled properly by examining the LEDs.

Front panel LEDs

The front panel of the VPN Router 2700 has a lighted Nortel Networks logo and two LEDs (Figure 8). These LEDs indicate the status of the VPN Router 2700.

Figure 8 Front panel LEDs

Alert

Boot/Ready

Power

Alert

Boot/Ready

CS160013A

Table 4 describes the LEDs on the VPN Router 2700 front panel.

Table 4 Front panel LED indicators

LED	Indicator	Description
Power (Nortel	On	The gateway is receiving AC power.
Networks logo)
	Off	The gateway is not receiving AC power.
Alert/Fail	Yellow	A non-fatal alarm condition exists. The yellow alert
		condition is described in the health check display.
	Red	A serious alarm condition exists that requires attention.
		A red alert usually indicates a hardware error. The red
		alert condition is described in the health check display.
Boot/Ready	Yellow	The gateway is booting and is in a non-ready state.
	Green	The boot process is complete and the gateway is in a
		state of readiness.

For complete information about the health check, event log, and system log, see Nortel VPN Router Troubleshooting (NN46110-602).

NN46110-311 02.01