Installing the Model 5625HD Switch Module
206208-A 3-9
Connecting Terminals and Management Stations
This section provides information about connecting terminals or PCs to the
service port on the Model 500xBH/BHC chassis. For information about
connecting a management station to an MCP module, refer to the using guide
shipped with that module.
Refer to Using SpeedView 4.0 for Windows and Release Notes for SpeedView 4.1
for information about advanced configuration and monitoring of the switch.
To connect a terminal to the Model 500xBH/BHC chassis service port, you need
the following equipment:
• A TTY-compatible terminal or a portable computer with a serial port and the
ability to emulate a TTY-compatible terminal. The terminal communication
parameters should be set for:
— 9600 baud (default)
— 8 data bits
— No parity
— 1 stop bit
— No handshaking
— Standard ASCII code
• An RS-232 modem cable with a female DB-9 connector to connect to the
service port on the chassis front panel. The cable should use the service port
pin assignments that are specified in Installation and Reference for the
Model 5000 Chassis and Installation and Reference for the Model 5005
Chassis.