Using the Model 5625HD EtherSpeed Switch Module
B-6 206208-A
Using Shielded Twisted Pair Cables
Type 1 shielded twisted pair (STP) cabling also o pera tes with 10B ASE-T Et hernet
and 100BASE-TX Fast Ethernet. Type 1 STP cable consists of tinned-copper
braided shield surrounding two data-grade twisted pairs of #22 A WG solid coppe r
conductors that have individual or S-shaped shields of aluminum-backed
insulating tape or metallized Mylar foil.
Type 1 cable generally is used between wiring closets or from the wiring closet
patch panel to the work area wall outlet.
Type 1 cable generally is terminated with an IBM four-position (MIC) data
connector. Nortel Networks Fast Ethernet supports 100BAS E-TX Fast Ethernet
over STP media through the application of a specialized balun media adapter, also
referred to as a Type 1 balun (Figure B-4). When adapting 150-ohm STP cable
plants for Fast Ethernet applications, balun media adapters are r equired at bo th the
hub and station ends of the STP cable plant. Media adapters (such as AMP part
number 558421-1) are available that plug into the RJ-45 patch cable connectors,
allowing the patch cable to connect with an IBM data connector. The media
adapter and patch cable provide impedance matching between UTP (100-ohm)
and STP (150-ohm) cabling.
Figure B-4. Fast Ethernet Type 1 Balun Media Adapter
Note: A balun media adapter is required when connecting 100-ohm RJ-45
100BASE-TX ports to a 150-ohm STP cable plant. This adapter provides
impedance matching between UTP (100-ohm) and STP (150-ohm) cabling.
Note: For additional information about AMP Type 1 balun media adapters
(part number 558421-1), contact your AMP reseller or distributor. The user
should verify that the combination of the STP cable plant and the impedance-
matching baluns meets the requirements of the applicable LAN standard.
6737