Nortel Networks L12 Cleaning, 110, Self-Timer Lamp/AF-Assist Illuminator LED, Batteries

Caring for the Camera

jThe Self-Timer Lamp/AF-Assist Illuminator LED

The light-emitting diode (LED) used in the self-timer lamp/AF- assist illuminator (c 4) conforms to the following IEC stan-

dard:

kBatteries

•Check the battery level when taking the camera out and replace the batteries if necessary (c 16). If possible, carry spare batteries when taking pictures on important occasions.

•Battery capacity tends to decrease on cold days. Be sure that the batteries are fresh before heading outside to take pictures in cold weather. Keep spare batteries in a warm place and exchange as necessary. Once warmed, a cold battery may recover some of its charge.

•Dirt on the battery terminals can prevent the camera from functioning.

•Used batteries are a valuable resource. Please recycle used batteries in accordance with local regulations.

Technical Notes

Cleaning

Lens

Avoid touching glass parts with your fingers. Remove dust or lint with a blower (typically a small device with a rubber bulb attached to one end that is pumped to produce a stream of air out the other end). To remove fingerprints or other stains that cannot be removed with a blower, wipe the lens with a soft cloth, using a spiral motion that starts at the center of the lens and work- ing toward to the edges. If this fails, clean the lens using a cloth lightly damp- ened with commercial lens cleaner.

Monitor

Remove dust or lint with a blower. To remove fingerprints and other stains, clean the monitor with a soft, dry cloth, being careful not to apply pressure.

Body

Use a blower to remove dust, dirt, or sand then wipe gently with a soft, dry cloth. After using the camera at the beach or seaside, wipe off any sand or salt with a dry cloth lightly dampened with fresh water, then dry thoroughly. Note that foreign matter inside the camera could cause damage not covered by the warranty.

Do not use alcohol, thinner, or other volatile chemicals.

110