Nortel Networks S80 Electronically Controlled Cameras

Troubleshooting

	Problem		Cause/Solution	A
		•	If camera clock has not been set, “Date not	20
			set” indicator blinks during shooting and
			movie recording. Pictures and movies
	Date and time of recording are		recorded before clock is set are dated “00/00/
			0000 00:00” or “01/01/2010 00:00”
	not correct
			respectively. Set the correct time and date
		•	from the Date option in the setup menu.
			Check camera clock regularly against more	148
			accurate timepieces and reset as required.
	No indicators displayed in	Auto info is selected for Playback in Monitor		151
	monitor	settings of the setup menu.
		•	Camera clock has not been set.	20, 148
	Date imprint not available	•	Another function that restricts the Date	76
			imprint option is enabled.
	Date not imprinted on pictures	•	Another function that restricts the Date	76
	even when Date imprint is	•	imprint option is enabled.
			Selected shooting mode does not support	152
	enabled
			date imprint
	Camera settings reset	Clock battery is exhausted; all settings were		149
		restored to their default values.
	Monitor turns off, and the	Battery temperature is high. Turn off camera and
	power-on lamp blinks green			19
Technical		allow battery to cool down before resuming use.
	rapidly.
			is turned off.
Notes		•	The battery is not charged when the camera	137
	Battery inserted into the	•	Charging stops if the computer enters sleep	137
			mode while the battery is charging. The
	camera is not charged when
and			camera may be turned off.
	the camera is connected to a	•
			Depending upon computer specifications,	137
Index	computer.
			settings, and status, it may be impossible to
			charge the battery inserted into the camera
			via computer connection.

Electronically Controlled Cameras

In extremely rare instances, unusual characters may appear in the monitor and the camera may stop functioning. In most cases, this phenomenon is caused by a strong external static charge. Turn the camera off, remove and replace the battery, then turn the camera on again. In the event of continued malfunction, contact your retailer or Nikon-authorized service representative. Note that disconnecting the power source as described above may result in the loss of any data not recorded to internal memory or the memory card at the time the problem occurred. Data already recorded will not be affected.

178