Switches 5 and 6 allow you to set a permanent EQ in that particular zone. You can set that zone to have a +4dB boost at 100Hz, a +4dB boost at 10kHz, a +4dB boost at both frequencies, or a flat response (Fig. 10).

Fig. 10: Switches 5 & 6, Zone EQ Presets

+4dB Boost

+4dB Boost

at 100Hz

at 10kHz

O 1 2 3 4 5 6 7 8

O 1 2 3 4 5 6 7 8

N

N

+4dB Boost

at 100Hz and 10kHz

O 1

2

3

4

5

6

7

8

N

 

 

 

 

 

 

 

Flat Response

O 1

2

3

4

5

6

7

8

N

 

 

 

 

 

 

 

Switch 7 allows you to group multiple keypads so that when a source is changed on one grouped keypad, all other grouped keypads will also change. This is handy for open floor plans where you might not want different sources interfering with each other. Source grouping is active when switch 7 is in the up position

(Fig. 11).

Switch 8 allows you to have the volume reset itself to a low level at power off. If this switch is in the up position, the audio volume will reset to a preset low level when

power is restored to that zone. If the switch is in the

down position, then the audio volume will return to its

previous volume level when the zone was turned off (Fig. 12).

Once the DIP switches for each zone are set, they can be installed in most standard J-boxes (we recommend the Slater model # S1-18-W), but not all. The width of the keypad is 51mm or 2 inches. It is important to make sure that the keypads are compatible with the J-boxes being used in the installation.

Fig. 11: Switch 7, Zone Grouping

Zone Group ON

Zone Group OFF

O 1 2 3 4 5 6 7 8

O 1 2 3 4 5 6 7 8

N

N

Fig. 12: Switch 8, Zone Volume Preset Volume low-level preset Set volume level

O 1 2 3 4 5 6 7 8

O 1 2 3 4 5 6 7 8

N

N

Page 11

Page 13
Image 13
Nuvo NV-E6XS Switches 5 & 6, Zone EQ Presets +4dB Boost At 100Hz At 10kHz, +4dB Boost At 100Hz and 10kHz Flat Response