3-7. Loading the Paper Roll

Be sure to use paper roll that matches the printer’s specification.

1 Push the cover open lever and open the printer cover.

2 Set the paper roll in the direction as shown, and pull on the leading edge of the paper towards you.

Cover open lever

Paper roll

Tension bar

Note:Make sure not to pass the paper under the tension bar. In the following condition, remove the tension bar unit and change the adjustmentleverpositioninaccordancewith theproceduresdescribedinparagraphs3-7-1 and 3-7-2:

• Paper thickness between 100 μm and 150 μm, or paper width of 57.5 mm on the vertical/wall-mount layout

Note:When using a paper roll with an 82.5 mm width, remove the paper roll holder in accordance with the procedure described in paragraph 3-7-3.

3Push both sides as shown in order to close the printer cover.

Note:When closing the printer cover, make sure both sides close firmly, not just one side.

– 12 –