3-7-2. Changing the Adjustment Lever Position

The adjustment lever position must be changed in accordance with the paper thickness. It is factory-set to position . When using paper thickness between 100 and 150 μm, change the adjustment lever position in accordance with the procedure below.

As shown, use a flat head screwdriver to move the adjust-

ment lever inward. Then, lower the adjustment lever to

the position in which the protrusion on the adjustment

lever engages with the hole in the frame.

Note:Do not use position .

Position

Position

Paper thickness

Paper thickness

between 65 μm and 105 μm

between 105 μm and 150 μm

3-7-3. Removing the Paper Roll Holder

When using a paper roll with an 82.5 mm width, remove the paper roll holder as shown. When using a paper roll with a 57.5 mm width, remove the paper roll holder, and install the paper roll holder into the other groove. In either case, change the setting at memory switch #4. For instructions on setting the memory switch, refer to the separate Specifications Manual.

Note:After using a paper roll with a width of 57.5 mm, do not change to a paper roll with a width of 79.5 or 82.5 mm. This is because the printer head has deteriorated as a result of a portion of the head having been in direct contact with the platen.

Paper roll holder

– 14 –