4. Attaching the Accessories
The following accessories do not necessarily have to be attached. Attach them if necessary.
• Holding plate
• Cable cover
• Switch blind
4-1. Attaching the Holder Plate
(1) Attach the shaft to the printer.
Shaft
Push in the left and right ends of the shaft.
(2)Wipe the area into which the rubber feet will be affixed in order to remove any grime; then, affix the roll stoppers. The positions for affixing them will vary depending on the paper width.
82.5 or 79.5 mm width | 57.5 mm width |
(3) Use a regular screwdriver to remove the clips at both ends of the bar to remove the tension bar unit.
– 17 –