Oki 407II 11-5.Wireless LAN Interface Model, ■LED Display, ■ Initializing Settings

■ Initializing Settings

Set the push switch as described below to initialize the setting information.

Push the switch for one to five seconds while running under normal operating mode. The green and red LEDs will flash with a regular pattern. After that, push the switch once again in that state to turn OFF both of the red and green LEDs. This will return the settings of the interface board to their default, or ex-factory, set- tings.After the interface board has been initialized, the printer will automatically reboot itself.

■LED Display

Green : Lights when other party connection is recognized as 100BASE-TX.

Red : Lights when packets are received.

LED

Push Switch

11-5. Wireless LAN Interface Model

ON					ON
OFF					OFF
	No. 1 2 3 4 5 6 7 8 9 10				No. 1 2 3		4
			DIP-SW 1			DIP-SW 2
					DIP-SW 1
Switch				Function					ON	OFF
1-1		Command emulation (Ster Line mode)						Always ON
1-2		Should not be changed (Should be set to on)
1-3		Should not be changed (Should be set to on)
1-4		Sensor adjustment						Invalid		Valid
1-5		Should not be changed (Should be set to on)
1-6		Handshaking conditions			(conditions for			Offline or receive		Receive buffer full
		BUSY)						buffer full
1-7		Should not be changed (Should be set to on)
1-8		Should not be changed (Should be set to on)
1-9		Low-power consumption mode						Invalid		Valid
1-10		Should not be changed (Should be set to on)

The factory settings of DIP switch are all on.

– 48 –