Oki 490 manual Setting Top of Form TOF, Forms Tear-Off OFF Default Setting

Setting Top of Form (TOF):

Forms Tear-Off OFF (Default Setting)

Important!

If you turn the platen knob when the printer is on, the Top of Form misaligns. Always turn the printer off before turning the platen knob!

Note: The first line prints at the red line (1) of the plastic paper shield on the printhead.

With paper loaded and the printer on and selected:

1Press SEL MENU (1) to take the printer off line. The SEL light goes out.

2Press and hold SHIFT (2), then

Note: When you begin pressing the Micro Feed key, the printhead will move to the right.

•Press LF Micro Feed Down (3) to set the TOF higher (the paper moves down).

•Press FF/LOAD Micro Feed Up (4) to set the TOF lower (the paper moves up).

3When you have the TOF set where you want it, press and hold SHIFT (2), then press QUIET/TOF (7) to engage the new setting.

The printhead moves back to the left margin.

4Press SEL/MENU (1) to save the setting and place the printer back on line.

Note: To reset the Top of Form to the factory default, see “Resetting Top of Form to the Factory Default” later in this chapter.

14Microline 490/491 User’s Guide